This is not a tool that is used in a job that would be good or bad, this is a person who uses these tools, a technician who makes a difference. The car polishing a good technician can do to look better finish than when you bought the car, and you would not have thought twice about how it could do, but in this short article, I'll go over some points that technicians know or should know.
The main problems when it comes to car stuff like finishing the paint work, sags, dirt and feathers just plain old general polishing. For starters, make sure that the dry end in accordance with data from the product list as a failure to do so can damage the finish, the whole business is very expensive.
the right way to polish:
When using polish, make sure it is special, and can be used for urethane finishes, and is not an easy finish. When sanding, make sure toto use a finer paper 1000grit ,as well as course sand paper can ruin the finish.
Polishing speed should be set for 1200 - 1700 rpm in order to ensure the best results. It is also very important to make sure you use the right type of pillow before you start. To know what the best type of pillow, always check the product data sheets and they will steer you in the right direction, do not forget, if you are in doubt, check the list.
to blend the edges when polishing Be sure to work far from the edge
and never directly into it. most recommended way to blend the edge of the machine handy icing than nails. When you have at hand glaze, always with a cloth that is not harsh, and make sure it is clean and the application of glaze, and when taking off.
Getting rid of imperfections:
As for polishing, always check with the right manufacturers product data sheet before grinding, or polishing, it will give you the recommended dry time before polishing. Always make sure that before you begin any work on the surface that you take off the debris and materials. If not, the results will be costly and disastrous.
It's so important to the proper prep work to be done so that the surface: Free imperfections such as dirt pens. You can use 1500 or higher grit for wet sanding to get rid of them. To make sure that no more irregularities on the surface, sand the surface of a block sander, not necessarily the entire surface, spot sanding will do.
The last step:
Use a light polish to remove sand scratches using the right liquid nails. When using polish, set it to 1200 - 1700 rpm and use the pad first. Next, you will need to use a sponge. Finally, you need non-abrasive glaze.
Always keep in mind that if you are in doubt about what to use or how to do this, consult the manufacturer's list of instructions and information sheet. Do not be in a hurry, if you take your time you won 't make mistakes you'll regret it.
0 comments:
Post a Comment